Clean - Panasonic ES‑LV74 Operating Instructions Manual

Clean

Cleaning using the self‑cleaning recharger
►Preparing the self‑cleaning recharger
Remove the shaver and the appliance plug from the
self‑cleaning recharger.
1
1
Place the self‑cleaning recharger on a hard, flat
surface.
• When the self‑cleaning recharger is lifted, or on
the soft surface such as carpets, the lock release
lever will not fit in the recharger properly. In that
case, the cleaning liquid unit cannot be removed.
2
2
Press the cleaning
liquid unit removal
button and remove
the cleaning liquid
unit.
3
3
Wash away the old cleaning liquid and beard
trimmings and then rinse the cleaning liquid unit.
• After washing, be sure to attach the cleaning
liquid filter.
40
ES-LV74_CH.indb 40
1
2
4
4
Pour tap water and
detergent into the
cleaning liquid unit.
• Do not let the water rise
above the maximum
water line. This may
cause the cleaning liquid
to spill.
5
5
Attach the cleaning liquid unit.
• Immediately wipe up any cleaning
liquid that has been spilt.
Be careful not to drop cleaning
liquid onto leather products or
wooden floors as it may cause
discoloration.
6
6
Press the top of the self‑
cleaning recharger down and
securely attach until it clicks.
►Notes
• The water and detergent will mix after cleaning
begins, making cleaning liquid.
• When the cleaning liquid level has dropped, the LOW
lamp will glow to indicate the cleaning liquid should be
replaced.
• After the LOW lamp glows, you can clean the shaver
with the self‑cleaning recharger for approximately
7 days.
1 2
2014/03/26 14:22:08