Panasonic ES-TLVK6 Operating Instructions Manual page 15

Mode
Charge
1 Charge
0 to 60 min
2 Clean/Dry/ Clean
Charge 10 min
• It is not possible to change the mode after the
"Clean/Dry/Charge" mode has started.
Dry
3 Dry/Charge
180 min
• It is possible to change to the "Clean/Dry/
Charge" mode even after the "Dry/Charge"
mode has started.
* When the ambient temperature of the self-cleaning recharger is
low (approx. 15 °C or lower), the time it takes to dry the shaver
increases.
• Use the self-cleaning recharger in temperatures between 15 °C
and 35 °C.
• The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the
STATUS lamp will glow for approximately 5 seconds and the
mode will switch to the "Charge" mode without allowing you to
select the "Clean/Dry/Charge" mode or the "Dry/Charge" mode.
ES-TLVK6_ASIA.indb 15
Time required (guide)
Dry
Charge
80 min
0 to 60 min
(170 min*)
Charge
0 to 60 min
Cleaning the shaver without the self-cleaning recharger
We recommend that you clean your shaver with the self-cleaning
recharger or the sonic vibration cleaning mode when the faucet
symbol appears on the lamp display.
1. Disconnect the cord from the shaver.
2. Apply some hand soap and some
water to the system outer foil.
3. Rotate the lock ring to unlock the
power switch.
4. Press the power switch for more than 2
seconds to activate the sonic vibration
cleaning mode.
• The battery capacity lamps blink in
order.
• After about 20 seconds, it will be
automatically turned off, or you can
turn it off by pressing the power
switch.
5. Remove the outer foil section and
press the power switch for more than
2 seconds to activate the sonic
vibration cleaning mode and clean it
with running water.
6. Wipe off any drops of water with a dry
cloth.
7. Dry the outer foil section and the
shaver completely.
8. Attach the outer foil section to the
shaver.
9. Lubricate the shaver.
The mark on the left means suitable for cleaning
under an open water tap.
4
5
7
15
2015/06/08 13:23:05