Before Cleaning; Setting; After Cleaning; Care And Cleaning - Siemens HB55NB550B Instruction Manual

Before cleaning

Remove accessories and cookware from the cooking
compartment.
Cleaning the cooking compartment floor
Before you set the cleaning system, clean the surfaces in the
cooking compartment that are not self-cleaning. Otherwise,
stains will develop that it is not possible to remove.
Use a dish cloth and hot soapy water or a vinegar solution. If
there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.

Setting

Æ Main oven
When you have selected a cleaning level, make the setting on
the oven.
Set the function selector to
1.
Use the temperature selector to set the cleaning level.
2.
The display shows the time at which the cleaning will end and
the arrow is next to the
N
a few seconds. You can see the time counting down and
the arrow is next to the
N
out.
Cleaning is finished
A signal sounds. The oven stops heating. 0:00 is shown in the
display. Turn the function selector to the off position. The oven
switches off.

Care and cleaning

With good care and cleaning, your oven will remain clean and
fully-functioning for a long time to come. Here we will explain
how to maintain and clean your oven correctly.
Notes
Slight differences in the colours on the front of the oven are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Cleaning system.
s
symbol. Cleaning will start after
y
symbol. The symbol goes
x y
Changing the cleaning level
Once the programme has started, you can no longer change
the cleaning level.
Cancelling cleaning
Turn the function selector to the off position. The oven switches
off.
Setting a later end time
You can delay the time at which the cleaning programme is due
to finish. For instance, you can set the cleaning programme to
run at night so that you can use your oven during the day.
Make the settings as described in steps 1 and 2. Before
cleaning starts, use the
@
The oven switches to standby. The display shows the time at
which the cleaning will end and the
symbol. When cleaning starts, you will see the time counting
down and the arrow will be next to the
N
symbol goes out.
Ç Top oven
Set the function selector for the top oven to
1.
heating.
Set the temperature selector to
2.
After approximately one hour, turn the function selector to the
3.
off position. The oven is switched off.

After cleaning

When the cooking compartment has cooled down completely,
wipe the salt residues off the self-cleaning surfaces with a
damp cloth.
Area Cleaning agents
Oven front Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues.
Special stainless steel cleaning products
suitable for warm surfaces are available
from our after-sales service or from
specialist retailers. Apply a thin layer of
the cleaning product with a soft cloth.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the Hot soapy water:
oven light Clean with a dish cloth.
Seal Hot soapy water:
Do not remove. Clean with a dish cloth. Do not scour.
Shelves Hot soapy water:
Soak and clean with a dish cloth or
brush.
or button to set a later end time.
A
arrow is next to the
N
symbol. The
x
Top/bottom
%
.
s
y
y
11