Before Running The Cleaning Function; Setting The Self-Cleaning Function; Once The Cleaning Function Has Ended; Cleaning Agent - Siemens HM676GB 1W Series Instruction Manual

Table of Contents

Advertisement

Cleaning agent

en

Before running the cleaning function

The shelf supports and pull-out rails can also be
cleaned at the same time. Remove the any coarse food
remnants manually before starting the cleaning function.
Remove accessories and cookware from the cooking
compartment. Only by doing this will you ensure that
you achieve good cleaning results throughout the entire
cooking compartment.
Clean the appliance door and along the edges of the
cooking compartment in the area around the seal. Do
not scrub or remove the seal.
Clean the inner door panel using hot soapy water and a
dish cloth. Dry with a soft cloth. If the cooking
compartment is heavily soiled, use oven cleaner.
:
Warning
Risk of fire!
Loose food remnants, fat and meat juices may catch
fire when the cleaning function is in progress. Before
you start the cleaning function, always remove the
worst of the food residues and remnants from the
cooking compartment.Do not use the cleaning
function for cleaning accessories.
The appliance will become very hot on the outside
Risk of fire!
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
If the door seal is damaged, a large amount of heat
Risk of fire!
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
:
Warning – Risk of serious harm to health!
The appliance becomes very hot when the cleaning
function is in progress. The non-stick coating on baking
trays and tins is destroyed and noxious gases are
released. Never clean non-stick baking trays or baking
tins using the cleaning function. In general, you must
not use the cleaning function for cleaning accessories.

Setting the self-cleaning function

Press the
button.
j
1.
The operating modes menu opens.
Select the "Self-cleaning" operating mode.
2.
Cleaning setting 3 is suggested. You can start the
cleaning process immediately using the
or
select a different cleaning setting using the rotary
3.
selector.
Press the
button to start the cleaning operation.
u
4.
Ventilate the kitchen when the cleaning function is
running.
The cooking compartment door locks shortly after
operation starts. The
H
mechanism appears on the right-hand side of the status
bar next to the elapsing duration.
The cooking compartment door cannot be opened until
the
symbol goes out in the status bar.
H
22
u
symbol for the locking
Once the cleaning has finished
An audible signal sounds. The oven stops heating.
"Finished" appears in the status bar. Use the
to switch off the audible signal.
Cancelling the cleaning operation
Use the "On/off" button to switch off the oven. The
cooking compartment door cannot be opened until the
H
symbol goes out in the status bar.
Cancelling the cleaning operation
Use the
k
compartment door cannot be opened until the
symbol goes out in the status bar.
You can set the cleaning to run overnight
In the section "Time settings", you can find out how to
delay the end time. This allows you to use the oven at
any time throughout the day. ~ "Time-setting options"
on page 16

Once the cleaning function has ended

Once the cooking compartment has cooled down, use
a damp cloth to wipe off the ash that has been left
behind in the cooking compartment, on the shelves and
around the appliance door.
Notes
During cleaning, the frame on the inside of the
appliance door may discolour. This is normal and
does not affect performance. The discolouration can
only be removed using a stainless-steel cleaning
agent.
Very bad soiling may cause white deposits to remain
on the enamel surfaces. This is residue from the
food and is harmless. It does not affect performance.
You can remove these residues using lemon juice if
required.
DCleaning agent
W ith good care and cleaning, your appliance will retain
C l e a n i n g a g e n t
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
button

Suitable cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Depending on the appliance
model, not all of the areas listed may be on/in your
appliance.
Caution!
Risk of surface damage
Do not use:
Harsh or abrasive cleaning agents,
Cleaning agents with a high alcohol content,
Hard scouring pads or cleaning sponges,
button to switch off the oven. The cooking
button
0
H

Advertisement

Table of Contents
loading

Table of Contents