Cleaning The Door Panels; Troubleshooting; Malfunction Table - Siemens HB55NB550B Instruction Manual

$
Fold back both locking levers (figure C). Close the oven
3.
door.
&
ã=
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Cleaning the door panels

To facilitate cleaning, you can remove the inner door panels
from the appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note: Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
Unhook the appliance door and lay it on a soft, clean surface
1.
with the front side facing downwards (see section: Removing
and installing the appliance door).
Unscrew the cover at the top left and right of the appliance
2.
door and detach it (figure A).
Lift the door panel and remove it (figure B).
3.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
% $
Removing the intermediate panel
Press the holder on the intermediate panel on one side and
1.
unlatch it, using a spatula for instance (fig. C).
Unlatch the other side in the same way and remove the
2.
intermediate panel.
&
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
Place the intermediate panel in the supports on the left and
1.
right (figure D).
Push the intermediate panel downwards in the retainers.
2.
'
Fitting the door panel
Slide in the door panel all the way.
1.
Put the cover back in place and screw it in.
2.
Refit the appliance door.
3.
Problem Possible cause Remedy/information
The oven does The circuit
not work. breaker is
defective.
Power cut
Power cut
0 and three
zeros light up in
the display.
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen
appliances are working.
Reset the clock.
13