Installation - AEG CCB6440BBW User Manual

30 www.aeg.com
Problem
You cannot activate the ap-
pliance.
Residual heat indicator does
not come on.
You cannot activate the out-
er ring.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation
settle on the food and in the
cavity of the oven.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

13. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The fuse is blown.
The zone is not hot because
it operated only for a short
time.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
You left the dish in the oven
for too long.
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
.........................................
.........................................
.........................................
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Activate the inner ring first.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.