Channel - Strong SRT 40FX4003 User Manual

English

5.4 Channel

5.4.1 Auto Tuning (in DVb-T/C mode only)
First select the Tune Type by pressing t u to select DVB-T, ATV or DVB-T+ATV (DVB-T to search digital
broadcasts and ATV to search analogue broadcasts). Press q to continue. Press pq t u to highlight
the country that you want to install, then press EnTER to start searching.
noTE:
5.4.2 Advanced Tuning (in DVb-S mode only)
Access the satellite settings essential for searching programmes through DVB-S sources.
Satellite Dish Settings
A set of satellite dish settings must be configured for each wanted satellite before performing a channel
scan.
Satellite
LNB Type
LNB Power:
22KHz
DISEqC1.0/1.1
Highlight Satellite and press EnTER to access the satellite list and select one. Highlight LNB Type and
press EnTER to select the LNB type. Make sure the 22KHz, DISEqC1.0/1.1 switch is corresponding to the
selected satellite. After the above steps are finished, press the bLUE button to search for channels.
5.4.3 DTV Manual Tuning (in DVb-T/C mode only)
Search and store programmes manually.
Select the source type DVB-T or DVB-C and search digital programmes manually. In the Channel menu,
select DTV Manual Tuning and press EnTER to access. Press t u to select a Channel No., and then press
EnTER to start the search. The search stops when a programme is found and this programme will be
stored in the current channel position. If you want to stop the search, press MEnU.
5.4.4 ATV Manual Tuning (in DVb-T/C mode only)
First select the source type of ATV. Then in the Channel menu, select ATV Manual Tuning and press
EnTER to access. Highlight and press pq to select Storage To 1 (maybe other number), Sound System
and Channel No.. Then select search and press EnTER to start the search. Press u for the unit to search
towards higher frequency. Press t for the unit to search towards lower frequency. The search stops
when a programme is found and this programme will be stored in the current channel position. If you
want to stop the search, press MEnU.
fine-Tune
Use this option to make small adjustments to tuning of an individual channel. Fine-tune is not
If you have an active antenna, turn it on in the Channel menu and then start
the scan.
Select the satellite for this TV.
Make sure the LNB type is corresponding to your dish.
Set the power supply for the LNB (usually 13/18 V).
Select the 22KHz to set 22K switch to ON/OFF. The Auto mode
(recommended) is used to switch 22KHz on or off depending on the LNB
type.
Select the DiSEqC mode for the selected LNB.
11