Channel - Strong SRT 32HY4003 User Manual

5.4 Channel

5.4.1 Auto Tuning (in DVB-T mode only)
First select the Tune Type by pressing t u to select DVB-T, ATV or DVB-T+ATV (DVB-T to search digital
broadcasts and ATV to search analogue broadcasts). Press q to continue. Press pq t u to highlight
the country that you want to install, then press ENTER to start searching.
NOTE:
5.4.2 Advanced Tuning (in DVB-S mode only)
Access the satellite settings essential for searching programmes through DVB-S sources.
Satellite Dish Settings
A set of satellite dish settings must be configured for each wanted satellite before performing a channel
scan.
Satellite
LNB Type
LNB Power:
22KHz
DISEqC1.0/1.1
Highlight Satellite and press ENTER to access the satellite list and select one. Highlight LNB Type and
press ENTER to select the LNB type. Make sure the 22KHz, DISEqC1.0/1.1 switch is corresponding to the
selected satellite. After the above steps are finished, press the BLUE button to search for channels.
5.4.3 Auto Tuning (in DVB-C mode only)
First select the Scan Type by pressing t u to select Full or Network Scan.
Selecting Full scan the TV will perform a complete scan on all frequencies. Selecting Network Scan it is
possible to insert a specific frequency. In this case it will be requested to insert a specific frequency and
Network ID, therefore use pq to select the option to change then press t u to insert the frequency
and the Network ID. By selecting auto the TV will search all frequencies.
5.4.4 DTV Manual Tuning (in DVB-T mode only)
Search and store programmes manually.
Select the source type DVB-T and search digital programmes manually. In the Channel menu, select DTV
Manual Tuning and press ENTER to access. Press t u to select a Channel No., and then press ENTER to
start the search. The search stops when a programme is found and this programme will be stored in the
current channel position. If you want to stop the search, press MENU.
5.4.5 DTV Manual Tuning (in DVB- C mode only)
Search and store programmes manually.
10
If you have an active antenna, turn it on in the Channel menu and then start
the scan.
Select the satellite for this TV.
Make sure the LNB type is corresponding to your dish.
Set the power supply for the LNB (usually 13/18 V).
Select the 22KHz to set 22K switch to ON/OFF. The Auto mode
(recommended) is used to switch 22KHz on or off depending on the LNB
type.
Select the DiSEqC mode for the selected LNB.