Fuel Pump - HYOSUNG GT 650 Service Manual

REMOUNTING
Remount the fuel tank and fuel cock in the reverse order
of removal.
CAUTION
Gaskets and
ones to prevent fuel leakage.
Tighten the fuel cock bolts evenly.

FUEL PUMP

REMOVAL
Remove the front seat and fuel tank.
Disconnect the fuel hoses
.
INSPECTION
WARNING
Gasolin is very explosive. Extreme care must be
taken.
Disconnect the fuel hose
hose and insert the free end of the hose into a recep-
tacle.
Check the fuel flow when starting the engine for a few
seconds by pressing the starter switch.
If the fuel flow is not found, check the fuel cock. (Refer
to page 4-1)
If the fuel cock and hoses are not fault, replace the fuel
pump.
REASSEMBLY
Carry out the assembly procedure in the reverse order
of disassembly.
Tighten the fuel pump mounting bolts.
Connect the fuel hoses
securely.
FUEL HOSE ROUTING :
Fuel hose (To carburetor)
Fuel hose (To fuel cock)
Vacuum hose (To carburetor vacuum pipe).
must be replaced with new
and vacuum hose
connect the suitable
and vacuum hose
FUEL SYSTEM 4-2