Brake System - HYOSUNG GT 650 Service Manual

◉ CLEANING AND LUBRICATING
● Wash the drive chain with kerosine. If the drive chain
tends to rust quickly, the intervals must be shortened.
Kerosene is a petroleum product and will provide
some lubrication as well as cleaning action.
● After washing and drying the chain, oil it with a
engine oil or chain lubricating oil.
CAUTION
The drive chain for this motorcycle is made of the
special material.
The chain should be replaced with a RK525XSO
for 『 『 』 』 . .
Use of another chain may lead to premature
chain failure.
CAUTION
Some drive chain lubricants contain solvents and
additives which could damage the X-Orings in
your chain.
Use Hyosung chain lube or an equivalent that is
specifically intended for use with X-Oring chains.

BRAKE SYSTEM

Inspect Interval
[ BRAKE ]
Inspect Initial 1,000 km and Every 6,000 km.
[ BRAKE HOSE & BRAKE FLUID ]
Inspect Initial 1,000 km and Every 6,000 km.
Replace the brake hoses Every 4 years,
Replace the brake fluid Every 2 years.
◉ BRAKE FLUID LEVEL CHECK
● Keep the motorcycle upright and place the handle-
bars straight.
● Check the brake fluid level by observing the lower
limit line (LOWER) on the front brake fluid reservoir.
● When the level is below the lower limit line (LOWER),
replenish with brake fluid that meets the following
specification.
Specification and Classification
(Front brake) : DOT 4
(Rear brake) : DOT 4
PERIODIC MAINTENANCE 2-14
CAUTION
Cleaning the chain with gasoline or commercial
cleaning solvents can damage X-Orings and ruin
the chain.
Clean the drive chain with kerosene only.
CAUTION
Do not spill any brake fluid on the brake pad of
disk.
"LOWER" LIMIT LINE
[ Front Brake ]