Table of Contents
Advertisement
2.5
Quick Start of RSB-6410
2.5.1
Debug Port Connection
1.
Connect the debug cable to RSB-6410 debug port.
2.
Connect the other side of the debug cable to USB-to-RS-232 cable then con-
nect to your PC.
2.5.2
Debug Port setting
RSB-6410 can communicate with a host server by using serial cables. Common
serial communication programs such as HyperTerminal, Tera Term or PuTTY can be
used in this case. The example as below describes the serial terminal setup using
HyperTerminal on a Windows host:
1.
Connect RSB-6410 with your PC by using a serial cable.
2.
Open Hyper Terminal on your Windows PC, and select the settings as shown in
Figure 2.1.
3.
After the bootloader is programmed on the SD card, insert the power adapter
connector to the DC jack on RSB-6410 to power up the board. The bootloader
prompt is displayed on the terminal screen.
Figure 2.1 Hyper Terminal Settings for Terminal Setup
RSB-6410 Android User Manual
34
Advertisement
Table of Contents
