Pci Expansion Slots; Rear I/O Ports; Server Chassis Features; System Power - Supermicro 6018R-WTR User Manual

PCI Expansion Slots

The X10DRW-i(T) has one (1) SMC-proprietary PCI-E 3.0 x16 slot, one (1) SMC-
proprietary PCI-E 3.0 x16+x16 slot, and one (1) PCI-E 3.0 x16 Add-On-Module
(AOM) slot for a mezzanine HBA card. PCI slots are controlled by CPUs: both CPUs
must be installed to utilize all slots. See Chapter 5 for details.

Rear I/O Ports

Ports on the I/O backplane include one COM port, a VGA port, four USB 2.0 ports,
two gigabit (6018R-WTR) or 10-gigabit (6018R-WTRT) Ethernet ports and one IPMI
port. A UID (Unit Identifi er) button and LED are also located beside the VGA port.
1-3

Server Chassis Features

The SuperServer 6018R-WTR(T) is built upon the SC815TQ-R706WB chassis.
Details on the chassis and on servicing procedures can be found in Chapter 6.The
following is a general outline of the main features of both chassis.

System Power

The SC815TQ-R706WB features both a primary and redundant 700/750 Watt power
supply (Part# PWS-706P-1R). The system does not need to be shut down when
replacing or removing a single power supply module.
Note: The power supplies are both redundant, hot-plug.

Hard Drive Subsystem

The SC815TQ-R706WB chassis was designed to support four 3.5" hot-swap SATA
hard drives. With a conversion kit (P/N: MCP-220-00043-0N) you can support
2.5" drives.
Note: For the 6018R-WTR, the hard drives are connected to four onboard SATA
connections from the SCU Controller.
PCI Expansion Slots
A riser card (RSC-R1UW-2E16-O-P) on the left side of the chassis can support two
PCI-E x16 add-on cards. See our webs site for details (http://www.supermicro.com/
products/info/UIO.cfm). See section 5-6 for further details.
1-3
Chapter 1: Introduction