MMIC2 board. In the ADF5904 Main Controls tab, click Initialize to Connect the SDP board to the EV-RADAR-MMIC2. power up the ADF5904. Connect the dc blocked TXOUT2 connector (J9) to the 10. In the ADF4159 Main Controls tab, click Write All spectrum analyzer.
Page 11
RADAR-MMIC2 evaluation board. Generate a 5 ms, 200 MHz triangular ramp (24.025 GHz Connect the SDP board to the EV-RADAR-MMIC2. to 24.225 GHz). Connect the dc blocked TXOUT2 (J9) connector to a delay In the ADF5904 Main Controls tab, click Initialize to cable or antenna.
Page 12
UG-866 EV-RADAR-MMIC2 User Guide DELAY CABLES BLOCKING CAPACITOR 20dB FIXED ATTENUATOR SDP-S ADAPTOR BOARD POWER SUPPLY OSCILLOSCOPE/ SPECTRUM ANALYZER –9V POWER SUPPLY Figure 8. Typical Evaluation Setup with Cables Rev. 0 | Page 12 of 23...
Page 13
EV-RADAR-MMIC2 User Guide UG-866 SDP-S ADAPTOR BOARD POWER SUPPLY OSCILLOSCOPE/ SPECTRUM ANALYZER –9V POWER SUPPLY Figure 9. Typical Evaluation Setup with Antenna Rev. 0 | Page 13 of 23...
By using the evaluation board discussed herein (together with any tools, components documentation or support materials, the “Evaluation Board”), you are agreeing to be bound by the terms and conditions set forth below (“Agreement”) unless you have purchased the Evaluation Board, in which case the Analog Devices Standard Terms and Conditions of Sale shall govern. Do not use the Evaluation Board until you have read and agreed to the Agreement.
Need help?
Do you have a question about the EV-RADAR-MMIC2 and is the answer not in the manual?
Questions and answers