Table of Contents
Advertisement
Clip management
Selecting clips
When performing operations on the thumbnail display screen, select the clip which will be the target of
these operations as follows.
1
Using
,
,
frame) to the target clip.
To move the cursor to left or right, use
You can also use
[ALT/3].
To move the cursor up and down, use
pressing and holding [ALT/3].
This operation on the rest of the pages in this
manual is referred to as "cross cursor operation".
Press
.
A bluish-green frame now appears at the clip
where the cursor is positioned to indicate that the
clip has been selected.
•
To allocate functions to the USER buttons, refer to "USER button" (Page 32).
•
[ALT/3] does not work when ALT function is not allocated to [ALT/3].
•
By repeating steps 1 and 2, you can select a multiple number of clips.
•
If you select a clip and move the cursor to another clip, and then press
[ALT/3], you can select from the last selected clip until the clip at the cursor position at a time.
•
To move from one page to another, press
To release the selection
1
Move the cursor to the selected clip, and press
The selection is released.
•
By pressing [EXIT/2] while pressing [ALT/3], you can cancel the selection of the selected clips all together.
Deleting clips
You can delete unwanted clips from the P2 card by proceeding as follows.
1
Display the thumbnail display screen.
Select the clips to be deleted.
Press [MENU/MODE CHK].
Using
,
and
– "DELETE", and press
5
Select "YES", and press
6
When the completion message has
appeared, press "OK" (
•
It may not be possible to delete clips for which the
displayed.
0
or
, move the cursor (yellow
or
by pressing and holding
, select "OPERATION"
.
.
).
or
.
or
by
or
of
.
again.
defective clip indicator or
X
while pressing and holding
unknown clip indicator is
?
Hide quick links:
Advertisement
Table of Contents
