Clip Management; Thumbnail And Clip Management - Panasonic AJ-HPM100P Operating Instructions Manual

Thumbnail and Clip Management

1
2
This unit provides a thumbnail screen for managing clips. A
clip is a single data item that contains video, audio, metadata
and other additional information. Normally, a clip is one shot
generated from the start of recording until recording stops.
However, when a shot spans multiple P2 cards, the video on
each card is handled as an independent clip.
The thumbnail screen shows a list of thumbnails. Each
thumbnail, which is the first frame of each clip, represents that
clip. These thumbnails allow you check and also perform the
following clip management operations.
• Play back, delete and repair clips
• Insert text memos in clips
• Check and delete text memos
• Display and delete markers
• Format P2 cards
• Show clip property
• Show P2 card status
◆ NOTE:
• Thumbnails are generated from part of the captured video and
therefore appear rougher than the actual video.
• Thumbnail screens are output also via the VIDEO MONITOR
connector but may run off the screen depending on the type of
monitor that is connected.
36
Clip Management: Thumbnail and Clip Management

Clip Management

17
3 4
16 8
011
7
6
5
7 15 14
X !
M P T E W
9 10 11 12 13