Table of Contents
Advertisement
Chapter 1
| Switch Description
Overview
Key Hardware
Components
Figure 1: Front Panel ECS3510-26P
1
10/100BASE-T Port LEDs
2
10/100BASE-T RJ-45 Ports 1-24
3
Gigabit SFP Slot / 1000BASE-T RJ-45 Combo Port 25
4
RJ-45 Console Port
The switch consists of several key hardware components. This manual describes
each specific component, or related components, together with their installation
requirements and procedures in each chapter. To understand each component in
detail, refer to the relevant section.
2
10/100BASE-T RJ-45 Ports
The switch contains 24 10/100BASE-T RJ-45 ports that support 10/100/1000BASE-T
copper links to other devices. For more information, see
Twisted-Pair Copper Ports" on page
Combination SFP/RJ-45 Ports
The switch contains two combo ports made up of two Small Form Factor Pluggable
( SFP) transceiver slots that are each logically connected with one of two 1000BASE-
T RJ-45 ports. At any one time, a "combo" port can only have one of the pair, the SFP
slot or the RJ-45 port, enabled. For more information on connecting the SFP ports,
see
"How to Connect to SFP Fiber Optic Ports" on page
Console Port
The RJ-45 connector on the front panel far right side that is labeled "Console"
provides an out-of-band serial connection to a terminal or a PC running terminal
emulation software. The port can be used for performing switch monitoring and
configuration. For more information, see
page
43.
1
5
System LEDs
6
Combo Port LEDs
7
Mode Button
8
Gigabit SFP Slot / 1000BASE-T RJ-45 Combo Port 26
34.
"How to Connect to the Console Port" on
– 10 –
8
7
6
3
4
5
"How to Connect to
38.
- Quick Links:
- How to Reset the Switch
Hide quick links:
Advertisement
Table of Contents
