Planet ADN-4101 User Manual page 41

The following table describes the parameters in this page.
Field
ADVANCED WIRELESS SETTINGS
Transmission Rate
Multicast Rate
Transmit Power
Beacon Period
RTS Threshold
Fragmentation
Threshold
DTIM Interval
Preamble Type
SSID
Enable Wireless
SSID
Visibility Status
User Isolation
Select the transmission rate of the wireless network
from the drop-down list.
Select the multicast transmission rate of the wireless
network from the drop-down list. You can select Lower
or Higher.
Select the power for data transmission from the
drop-down list. You can select 100%, 80%, 60%, 40%,
or 20%.
By default, the wireless beacon frame sends the data
once every 100ms. Its value range is 20—1024.
The threshold of transmission request. Its value range
is 0—2347 and the default value is 2346.
Its value range is 256—2346 and the default value is
2345.
Data beacon proportion (transmission quantity
indication). Its value range is 1—255 and the default
value is 100.
Select the preamble code from the drop-down list. You
can select long or short.
Select or deselect the check box to enable or disable
the wireless function.
Set the wireless network name, that is, SSID. SSID is
used to distinguish different wireless networks.
Select whether to hide the AP. You can select Visible
or Invisible. If you select Invisible, the AP is hidden
and the terminal cannot obtain the SSID through
passive scanning.
Select whether users of the AP can communicate with
each other. You can select Off or On from the
drop-down list. On indicates that computers connected
to the device cannot communicate with each other.
35
Description