Planet ADN-4101 User Manual page 33

LAN, the IP address pool used for DHCP must be compatible with the IP address
of the device. The IP address available in the DHCP IP address pool changes
automatically if the IP address of the device changes.
You can also enable the secondary LAN IP address. The primary and the
secondary LAN IP addresses must be in different network segments.
Choose Setup > Local Network. The Local Network page as shown in the
following figure appears:
By default, Enable DHCP Server is selected for the LAN interface of the device.
DHCP service provides IP settings to workstations configured to automatically
obtain IP settings that are connected to the device through the Ethernet port.
When the device is used for DHCP, it becomes the default gateway for DHCP
client connected to it. If you change the IP address of the device, you must also
change the range of IP addresses in the pool used for DHCP on the LAN. The IP
address pool can contain up to 253 IP addresses. You can also make DHCP
server just acting on the specific port, by default, those ports are selected.
If your DHCP server doesn't belong to the same segment with your pc, but you
need to assign IP address from DHCP server, you must uncheck the Enable
27