Table of Contents
Advertisement
24
EN
Recording Features
● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
Record One Programme While
Watching Another
Once recording is in progress, all you need to do is to set
the channel controls on the TV for the station you wish to
view.
● The programme selected with the TV's channel controls
appears on the TV screen, while the one selected with the
unit's PR buttons is recorded on the tape.
NOTE:
You can also use the DVD deck in the following cases. Before
use, be sure to turn on the unit and select the DVD deck.
● During recording
● During timer recording
● During timer standby mode
Instant Timer Recording (ITR)
This easy method lets you record for
from 30 minutes to 6 hours (selectable in
30-min. increments), and shuts the unit
off after recording is finished.
1
Start recording.
Press 7 on the unit.
2
Engage the ITR mode.
Press 7 again. " " blinks and "0:30" appears on the
front display panel.
OPERATIONS ON VHS DECK (cont.)
3
Set the recording duration.
If you want to record for more than 30 minutes, press 7
to extend the time. Each press extends recording time by
30 minutes.
NOTES:
● You can only perform ITR using the 7 button on the unit's
front panel.
● When the end of the tape is reached during Instant Timer
Recording, the unit is turned off and "
the front display panel.
● When the end of the tape is reached during timer recording,
the unit is turned off and "
display panel.
Elapsed Recording Time Indication
1
Set the counter display.
Press – –:– – until a counter reading appears on the front
display panel.
2
Reset the counter.
Press 0000 before starting recording or playback.
● The counter is reset to "0:00:00" and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press – –:– – until the time remaining on the tape
appears.
● The front display panel shows the tape remaining time with
"z" displayed.
NOTES:
● By pressing the – –:– – button, you can change the display to
show the clock time, counter reading or tape remaining time.
● When you press – –:– –, the on-screen display appears on the
TV screen for 5 seconds.
● Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
"– –:– –" may sometimes appear, or the display may blink on
occasion.
" and "$" blink on
", "
" and "
" blink on the front
7
4
#
Advertisement
Table of Contents
