JVC HR-XV3AG Instructions Manual page 32

32
EN
Before performing the following steps:
● Make sure the satellite receiver is connected to the unit's
L-1 Input Connector (INPUT (L-1))
● Programme the timer on the satellite receiver.
● Insert a cassette with the safety tab in place.
● Slide the TV/VCR/DVD switch to the right.
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Set the tape speed.
Press p.
C
Engage the Automatic Satellite Programme
Recording mode.
On the unit
Press and hold REC LINK
for about 2 seconds.
On the remote control
Press and hold REC LINK
for about 2 seconds.
● The "N" and "#" indicators
light up and the unit turns
off automatically.
● Operation on the DVD deck is not possible when the
● To disengage the Automatic Satellite Programme Recording
connector.
● If the unit's power is off, it is not possible to engage the
● In step C, if the "N" indicator does not light but instead blinks
● The "N" indicator blinks while Automatic Satellite Programme
● For timer programming of the satellite receiver, refer to the
● Automatic Satellite Programme Recording is not possible if
● Pressing the unit's 1 button while Automatic Satellite
● If there are more than one satellite programmes you wish to
● Depending on the type of satellite receiver, the unit may not
● If you engage the Automatic Satellite Programme Recording
● You can also record a programme from your cable system in
● The B.E.S.T. system (
OPERATIONS ON VHS DECK (cont.)
Automatic Satellite Program Recording mode is engaged, or
Timer Recording is in progress.
mode, press REC LINK. The "N" indicator goes off.
Automatic Satellite Programme Recording mode.
quickly even though your satellite receiver's power is off,
Automatic Satellite Programme Recording will not work
properly with that satellite receiver*.
* Some satellite receivers output signals even if the power is off.
Automatic Satellite Programme Recording is not possible with those
satellite receivers.
Recording is in progress.
instruction manual of the satellite receiver.
your satellite receiver does not have a timer.
Programme Recording is in progress turns off the unit's power
and disengages the Automatic Satellite Programme Recording
mode.
record with Automatic Satellite Programme Recording, it is not
possible to set different tape speeds for each programme.
record a slight portion of the beginning of the programme or
may record slightly longer than the actual length of the
programme.
mode when the satellite receiver's power is on, the unit will
not start Automatic Satellite Programme Recording even
though the "N" and "#" indicators blink. When the satellite
receiver shuts off once and is turned back on again, the unit
starts recording.
the same way if the system has a timer.
pg. 25) does not work while Automatic
Satellite Programme Recording is in progress.