Table of Contents
Advertisement
EDITING (VHS DECK)
Edit From A Camcorder
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/VCR/DVD switch to the right.
Recorder
AUDIO input
Audio cable (not provided)
Video cable (not provided)
VIDEO input
VIDEO OUT
AUDIO OUT
EDIT
Player
A
Connect the camcorder's AUDIO OUT and VIDEO OUT
connectors to the unit's front panel AUDIO and VIDEO
input connectors.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
● When a Master Edit Control-equipped JVC camcorder is used,
the camcorder is capable of controlling the unit. Refer to the
camcorder's instruction manual for operating procedure.
B
On the unit
To PAUSE
Press VCR/DVD repeatedly so that the VCR indicator
connector
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
Mini-plug cable
C
(not provided)
(JVC camcorder
only)
Press AUX (number key "0") and/or PR to select "F-1".
D
See "PICTURE CONTROL" on page 66.
E
Use 4, 3, or 5 to locate the point where you start
recording, then press and hold 9 and press 7 to engage
the Record Pause mode.
F
Engage the Play mode of the camcorder.
G
Press 4 to engage the Record mode of the unit.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
Make connections.
Select the VHS deck.
Set the unit's input mode.
Set the edit mode.
Engage the Record Pause mode.
Start the camcorder.
Start the unit.
57
EN
Advertisement
Table of Contents
