Resetting The Radio Gateway In Delivery Condition - Siemens FDCW221 Technical Manual

Commissioning
8.6

Resetting the radio gateway in delivery condition

38
Building Technologies
Fire Safety & Security Systems
The radio gateway is reset in delivery condition when the existing configuration
shall be deleted. This is the case when e.g. the radio gateway shall occupy a
different basis channel.
The radio gateway is reset in the delivery condition.
An existing configuration is deleted.
Prerequisite
The FDnet detector line must be switched off.
Procedure:
1. Unlock the housing cover of the radio gateway on the front side with pin and pull
it off.
2. Pull off the battery connector for at minimum 10 seconds, than plug it in again.
Wait until the green LED flashes rapidly.
3. Briefly press the button in the radio gateway while the green LED is flashing.
The radio gateway is initialised and set into configuration mode. This is
indicated by alternating, slow flashing of the red and green LEDs.
A free basis channel is automatically searched for and the result is indicated:
Channel found: green LED flashes slowly
–
No channel found: red LED flashes slowly
–
4. Register the radio detector at the radio gateway.
see also:
8.3 Register the radio detector at the radio gateway, Page 34
009865_b_en_--.doc
11.2007