Canopy Assembly; Blade Assembly - Ellington MXW36ABZ5 Installation Manual

8. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws that were previously removed (on page
3, Section 4) and secure all screws with Phillips
screwdriver.

9. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. [Note: Use slot located on fitter plate for
easy access to motor screw holes with
screwdriver.] Before securing screws
permanently, repeat procedure with remaining
blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
slotted
hole
slot in
fitter plate
plastic
motor
lock
lock
washers
page 7
hanging bracket
canopy
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
blade