ESAB EPP-200 Instruction Manual page 98

SECTION 4
4.2 Operating the EPP-200 Console
4.2.1 Console Controls
4
3
5
6
1
2
7
Pilot Arc Switch
Used to select pilot arc current range when Remote / Panel Switch is in
the Panel position. HIGH position is used for most cutting applications.
Electrode life is adversely aff ected when used in high position when low
is suitable. Starting may be diffi cult if set on low when high is required.
Related to the initial torch standoff height.
Cutting Voltage and Current Meters
"A" meter indicates actual cutting current, 0-200 amperes
"V" meter indicates actual output voltage, 0-160 VDC
Output Current Control
Sets the cutting current when current settings are made from the
power console front panel. (The Remote/Panel switch must be in the
Panel position.)
Remote/Panel Switch
Panel position – Output current is set by the output current control
on the console front panel as described above.
Remote position – Output current is set by the CNC with an analog
dc signal.
1 Pilot Arc High/Low Switch
2 Cutting Voltage and Cutting Current Meters
3 Output Current Control
4 Remote/Panel Selection Switch
5 Gas Test Switch
6 Fault Lights
7 Main Power Switch
98
OPERATION