ESAB EPP-200 Instruction Manual page 90

SECTION 3
CAUTION
3.3 Placement
Plasma
Console
CAUTION
3.4 Input Connections to Console
WARNING
Do Not Restrict Air Flow
Restricting intake air with any type of fi lter on or around the Plasma
console will result in overheating and may void the warranty.
• A minimum of 2 ft. (0.61m) clearance for cooling air fl ow.
• Plan for top panel and side panels having to be removed
for maintenance, cleaning and inspection.
• Locate the EPP-200 relatively close to a properly fused
electrical power supply.
• Keep area beneath power source clear for cooling air
fl ow.
• Environment should be relatively free of dust, fumes and
excessive heat. These factors will aff ect cooling
effi ciency.
Conductive Dust And Dirt Inside Power Source May
Cause Arc Flash Over
Equipment damage may occur. Electrical shorting may occur if
dust is allowed to buildup inside power source. See maintenance
section.
Electric Shock Can Kill!
Provide maximum protection against electrical shock.
Before any connections are made inside the machine, open the
line wall disconnect switch to turn power off .
90
INSTALLATION