Configuring Frts - HP A6600 Configuration Manual

In FR class view, configure QoS parameters for QoS services such as FRTS, FR traffic policing, FR congestion
management, and FR queuing. See the subsequent sections for detailed parameter configurations.

Configuring FRTS

To do...
1. Enter system view.
2. Enter FR interface view.
3. Enable FRTS.
4. Return to system view.
5. Enter FR class view.
6. Set CBS for FR PVCs.
7. Set EBS for FR PVCs.
8. Set CIR ALLOW for FR PVCs.
9. Set CIR for FR PVCs.
10. Enable FRTS adaptation.
Command...
system-view
interface interface-type
interface-number
fr traffic-shaping
quit
fr class class-name
cbs [ outbound ]
committed-burst-size
ebs [ outbound ]
excess-burst-size
cir allow [ outbound ]
committed-information-rate
cir
committed-information-rate
traffic-shaping adaptation
{ becn percentage |
interface-congestion
number }
127
Remarks
—
—
Required.
Disabled by default.
FRTS applies to the outgoing FR packets. It
is typically applied on DTE.
—
—
Optional.
56,000 bps by default.
Use cbs, ebs, and cir allow commands to
set both inbound and outbound
parameters for FR PVCs. However, only
outbound parameters take effect for FRTS.
To ensure large-size packets can pass
through, set CBS less than CIR ALLOW.
Optional.
0 bit by default.
Optional.
56,000 bps by default.
Optional.
56,000 bps by default.
Optional.
By default, the command is enabled with
the percentage argument of 25 for traffic
with the BECN flag.