Table of Contents
Advertisement
Available languages
Available languages
HOPPER DUMPING
1.
Stop the machine and turn the ignition key (2) to "0".
2.
Remove the hopper (14) by using the transport handle (15) and the wheels (16) to drag it at the waste collection centre, then
empty it.
3.
Reinstall the hopper on the machine.
4.
The machine is ready to start sweeping again.
NOTE
When the hopper is removed, all machine functions are disabled.
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
–
Turn on the manual filter shaker with the handle (52).
–
Turn the ignition key (2) to "0" to stop the machine.
–
Empty the hopper (14) (see the procedure in the previous paragraph).
–
Lift the side brooms (18) and (19, optional), by pulling the levers (12) and (13, optional) onwards.
–
Make sure that the machine cannot move independently.
–
Charge the batteries (see the procedure in Maintenance chapter).
PUSHING THE MACHINE
The machine can be pushed both with the ignition key (2) to "0" and to "I".
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
–
Perform the procedures shown in After Machine Use paragraph.
–
Check that the machine storage area is dry and clean.
–
Disconnect the battery connector (36).
–
Slightly lift the machine so that the skirts, the main broom and the wheels do not touch the ground.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.
USER MANUAL
1465380000 - FLOORTEC 760
ENGLISH
13
Advertisement
Chapters
Table of Contents
