Carrier MMY-MAP0724FT9UL Service Manual page 238

No. Part to be replaced
9 Pipe fixing rubber
- detachment/
attachment
(common)
Work procedure
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving
a replacement part or some other object.
1. Detachment
1) Hold the pipe fixing rubber in such a manner that
your fingers and thumb are in contact with the two
longitudinal ends of the piece, and squeeze it a little
to create a small gap between the rubber and the
SUS band wrapped around it.
2) Push the hook end of the SUS band down to
disengage the hook from the square hole.
2. Attachment
1) The pipe fixing rubbers use a two-segment design to
accommodate a wide range of pipe combinations.
When installing them, therefore, it is recommended
to first split them up into segments and pair the
segments up only after placing them on pipes of
matching sizes separately. In this regard, make sure
that the mating tooth and slit of pairing segments
face each other.
2) When placing an SUS band around pipe fixing
rubber, make sure that the hook end of the SUS
band coincides with the slit side of the rubber.
(The band can be placed the other way around, but
only at the expense of work efficiency.)
3) Place the SUS band tightly around the pipe fixing
rubber so that there is no gap between them.
Take utmost care not to create a gap over the curved
section of the rubber where the hairpin side of the
band is located.
4) While holding the rubber, push down the base of the
hook lightly against the rubber, and engage the hook
with the square hole by squeezing the curved section
of the rubber where the square hole side of the band
is located (see the arrow).
(If the hook does not engage with the square hole,
recheck whether there is a gap between the band
and rubber.
– 238 –
Remarks
1)
Squeeze rubber to create small gap.
2)
Push band down in arrow direction.
Place two segments of damper on pipes of
matching sizes separately, making sure tooth and
slit of pairing segments face each other.
1)
Align tooth and slit and push two
segments towards each other.
2)
Make sure that hook end of SUS band
coincides with slit side of rubber.
Push square hole end of tape in
3)
arrow direction by squeezing rubber.
Push square hole end of tape in
arrow direction by squeezing rubber.
4)
Press down hook side of
tape against rubber.
Slide it along.