Makita HR3200C Technical Information page 8

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Tool Holder Section
DISASSEMBLY
3) HR3200C, HR3210C: Separate Tool holder section from Cylinder section, and remove Impact bolt from Tool holder.
(Fig. 14) Now Rings on Impact bolt are ready to be replaced in the next step.
3A) HR3210FCT: Separate Tool holder guide section from Cylinder section, and remove Impact bolt from Tool holder
guide. (Fig. 14A) Now Rings on Impact bolt are ready to be replaced in the next step.
4) If Dust is recognized inside Tool holder (Tool holder guide) after removing Impact bolt, make the inside clean.
Fig. 14
Flat washer 34: 2 pcs.
Pin 6 joining Tool holder
to Cylinder 25: 4 pcs.
Urethane ring 34
Screwdriver
magnetized
with 1R288
1. Remove Flat washer 34
and Urethane ring 34.
2. Apply magnetized
Screwdriver to Pin 6,
Fig. 14A
Flat washer 34: 2 pcs.
Pin 6 joining Tool holder
to Cylinder 25: 4 pcs.
Urethane ring 34
Screwdriver
Pin 6
magnetized
with 1R288
1. Remove Flat washer 34
and Urethane ring 34.
2. Apply magnetized
Screwdriver to Pin 6,
HR3200C, HR3210C
Cylinder 25
Tool holder
Pin 6
Cylinder 25
Tool holder
3. Align Tool holder's hole
with that of Cylinder 25
by pushing Tool holder.
Cylinder 25
Tool holder guide
Cylinder 25
Tool holder guide
3. Align the Hole of Tool
holder guide with that of
Cylinder 25 by pushing
Tool holder guide.
Pin 6: 4 pcs.
Tool holder section
4. Remove Pin 6 with
magnetized Screwdriver
when the both holes are
aligned each other.
HR3210FCT
Pin 6: 4 pcs.
Remove Tool holder guide and Striker
from Cylinder 25. And then, pull out
Impact bolt from Tool holder guide.
4. Remove Pin 6 with
magnetized Screwdriver
when the both holes are
aligned each other.
Impact bolt
Cylinder section
Striker
Remove Tool holder and Striker
from Cylinder 25. And then, pull
out Impact bolt from Tool holder.
Tool holder
Impact bolt
guide section
Cylinder section
Striker
P 8 / 24