Makita HR3200C Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Chuck Section (Model HR3200, HR3210C)
DISASSEMBLY
1) Remove Controller and Handle section and then upright the machine as illustrated in Fig. 5.
2) Disassemble Chuck section as illustrated in Fig. 6.
Fig. 5
Controller
4x18 Tapping screw: 2 pcs.
Fig. 6
Tool holder cap
Chuck
cover
Remove Tool holder
cap with Slotted
screwdriver.
[3] -1A. Chuck Section (Model HR3210FCT)
DISASSEMBLY
1) Remove Handle section and then upright the machine. (Fig. 5) Separate Tool holder assembly from the Machine. (Fig. 7)
Fig. 7
Change
cover
While pressing down Change cover, pull off Tool holder assembly.
Compression spring 11
5x25 Tapping screw : 2 pcs.
Chuck cover
Ring
spring 19
Guide
Ring 21
washer
Steel
ball 7
Chuck cover can be
removed by hand.
And then, remove
Ring spring 19.
Ring 21 can be
removed.
Tool holder assembly
Change
cover
Handle section
M5x20 Pan head
screw: 2 pcs.
Screwdriver
magnetized
Steel ball 7: 2 pcs.
with 1R288
Guide
washer
Remove Steel ball 7 with
magnetized Screwdriver,
while pressing down Guide
washer.
Tool holder assembly
Tool holder guide
P 5 / 24
Guide
Tool
washer
holder
Conical compression
spring 22-32
Remove Guide washer
and Conical compression
spring 22-32.
Washer 28
Retaining ring S-28