Makita HR3200C Instruction Manual
Hide thumbs
Also See for HR3200C:
- Instruction manual (72 pages) ,
- Technical information (24 pages) ,
- Instruction manual (37 pages)
Related Manuals for Makita HR3200C
Summary of Contents for Makita HR3200C
- Page 1 INSTRUCTION MANUAL Rotary Hammer HR3200C HR3210C HR3210FCT 008536 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
ENGLISH SPECIFICATIONS Model HR3200C HR3210C HR3210FCT Tungsten-carbide tipped bit 32 mm Concrete Core bit 90 mm Capacities Steel 13 mm Wood 32 mm No load speed (min 315 - 630 Blows per minute 1,650 - 3,300 Overall length 398 mm... -
Page 3: Specific Safety Rules
If operating a power tool in a damp location is 20. Store idle power tools out of the reach of unavoidable, use a ground fault circuit children and do not allow persons unfamiliar interrupter (GFCI) protected supply. Use of an with the power tool or these instructions to GFCI reduces the risk of electric shock. -
Page 4: Functional Description
to produce vibration. The screws can come CAUTION: loose easily, causing a breakdown or accident. Before plugging in the tool, always check to see • Check tightness of screws carefully before that the switch trigger actuates properly and operation. returns to the "OFF" position when released. In cold weather or when the tool has not been To start the tool, simply pull the switch trigger. - Page 5 Grasp the change cover and place the quick change drill Number on Revolutions per chuck on the spindle of the tool. Blows per minute adjusting dial minute Make sure that the quick change drill chuck is secured 3,300 by trying to pull it several times. 3,100 2,500 Selecting the action mode...
- Page 6 Side grip CAUTION: Do not rotate the change lever when the tool is 1. Side grip • running under load. The tool will be damaged. To avoid rapid wear on the mode change • mechanism, be sure that the change lever is always positively located in one of the three action mode positions.
-
Page 7: Operation
Dust cup 1. Bit 2. Chuck cover 1. Dust cup 008544 001300 Bit angle (when chipping, scaling or Use the dust cup to prevent dust from falling over the demolishing) tool and on yourself when performing overhead drilling 1. Change lever operations. - Page 8 2. Ring 1. Blow-out bulb 008553 002449 For Model HR3200C,HR3210C Use the optional drill chuck assembly. When installing it, After drilling the hole, use the blow-out bulb to clean the refer to "Installing or removing the bit" described on the dust out of the hole.
-
Page 9: Maintenance
2. Screws Wipe out the old grease inside and replace with a fresh grease (30 g). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 30 g) can cause faulty hammering action or tool failure. - Page 10 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. SDS-Plus Carbide-tipped bits • Bull point • Core bit •...
- Page 12 Makita Corporation 884769-2...