Makita HR3200C Technical Information page 18

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -6. Gear Section in Crank Housing Complete
ASSEMBLY
3) Assemble Spiral bevel gear 37, Link arm, Seal ring B and Link plate as illustrated in Fig. 39.
4) Assemble Crank cap as illustrated in Fig. 40.
5) Assemble Crank cap cover. The triangle mark on Change lever has to designate the mark of Rotary hammer mode on
Crank cap cover as illustrated in Fig. 31.
Fig. 39
Push Spiral bevel gear 37 into
Crank housing complete until
it stops.
Spiral bevel gear 37
Fig. 40
Link plate
6) Assemble the remaining parts by taking the reverse of the disassembling steps.
Push Link arm into Crank housing complete
until the notches of Link arm come into
sight in Crank housing complete.
Notches of The notches of Link arm
Link arm come into sight.
Crank cap
Assemble Crank cap to Crank housing complete
while keeping Change lever in the position
illustrated in Fig. 31A.
Pin of Spur gear 33 complete which is mounted on
the reverse side of Crank cap is fit into this hole.
Assemble Link plate by
fitting its bosses to the
notches of Link arm.
Seal ring B
Boss
Link plate
P 18 / 24