Makita HR3200C Technical Information page 14

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Motor Section, Torque Limiter Section
DISASSEMBLY
6) Disassemble Armature as illustrated in Figs. 28 and 29.
Fig. 28
5x25 Tapping screw: 4 pcs.
Remove 5x25 Tapping screws. And separate Motor housing from Gear room.
Do the disassemble work on the cloth to accept the grease from Gear housing
and to provent Torque limiter from having damage.
Fig. 29
Torque limiter
section
Remove Torque limiter section by striking the Gear housing's
edge with Plastic hammer, if Torque limiter section is left on
the Gear housing.
7) Torque limiter section can be disassembled as illustrated in Fig. 30.
Fig. 30
1R269
Ball bearing
608DDW
ASSEMBLY
Take the reverse step of the disassembling procedure. Refer to Figs. 30 to 25.
Crank Gear housing
housing
Cup washer 18
Note: Be careful not to lose
Cup washer 18 for
Crank shaft.
Torque limiter
complete
Ring 10
Torque limiter section may be left
in Crank housing at this time.
Torque limiter section
Armature
Use cloth to accept the grease from Gear
room and to provent Torque limiter from
having damage.
Handle
of 1R045
Remove Armature from Gear housing.
Key 4: 2 pcs.
P 14 / 24
Motor housing
1R346
Armature
Ball bearing 6001LLU
Spiral bevel
gear 9