Makita HR3200C Technical Information page 11

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Active Dynamic Vibration Absorber
DISASSEMBLY
1) Disassemble Handle section. (Fig. 5)
2) HR3200C, HR3210FC: Disassemble Chuck section. (Fig. 6)
2A) HR3210FCT: Disassemble Tool holder assembly. (Fig. 7)
3) Disassemble Crank housing cover. (Fig. 13) And remove Crank cap cover as illustrated in Fig. 21.
4) Remove Active Dynamic Vibration Absorber from Crank housing complete as illustrated in Fig. 22.
And disassemble as illustrated in Fig. 23.
Fig. 21
Fig. 22
Disassemble Active Dynamic Vibration Absorber as follows.
Compression
Absorber holder of
spring 11
Crank housing complete
Push Spring guide
Pipe holder
(inner part of
Absorber).
Spring guide
Phillips
screwdriver
Fig. 23
Pipe holders can now be
separated by turning Pipe
holders while pushing
strong toward each other.
4x14 Tapping screw: 2 pcs.
Crank cap cover
The Spring guide tilts to be
locked inside Absorber,
and the end of Absorber is
released from Crank housing
complete.
Absorber holder
Compression spring 10
Pipe holder
O ring 8
O ring 8
Spring guide
Disassemble Active dynamic
vibration absorber by levering up
Phillips
with two Slotted screwdriver.
screwdriver
Compression spring 10
Pipe 15
O ring 18
O ring 18
Counter weight
P 11 / 24
Slotted screwdriver
Active dynamic
vibration absorber
Pipe holder
O ring 8
O ring 8
Spring guide