Calling Up The Service Menu; Scanning Operating Data - Viessmann vitotronic 200-h Installation And Service Instructions Manual

Vitotronic 200-H, HK1B Installation and Service

Calling up the Service Menu

Service

Scanning Operating Data

Diagnosis
Actuator test
Coding level 1
Coding level 2
Fault history
Service functions
Terminate service?
Service menu overview
Press OK and simultaneously for approx. 4 sec.
General
Heating circuit 1 HC1
Heating circuit 2 HC2*
Heating circuit 3 HC3*
DHW
Solar
Brief scan
Reset data
Participant check
Service PIN
Vitocom PIN input
Service reset
Note: "Coding level 2" is only displayed if this level has
been enabled:
Press OK and simultaneously for approx. 4 sec.
The service menu is exited automatically after 30 min.
* With an extension module for circuits 2 & 3
(optional accessory)
Operating data can be scanned in six areas (see
"Diagnosis" in the overview "Service menu").
Operating data on "Solar" can only be scanned if the
components are installed in the system.
For further information on operating data, see chapter
"Brief scan".
Note: "- - -" appears on the display if a scanned sensor
is faulty.
Calling up operating data
1. Press OK and simultaneously for approx. 4 sec.
2. "Diagnosis"
3. Select required group, e.g. "Solar".
Resetting operating data
Saved operating data (e.g. hours run) can be reset to 0.
The value "Adjusted outside temp" is reset to the actual
value.
1. Press OK and simultaneously for approx. 4 sec.
2. "Diagnosis"
3. "Reset data"
4. Select required value or "All details".
Service Scans
33