Lexmark XM3150 User Manual page 168

Understanding the printer menus
Use
Timeouts
Standby Mode
Disabled
1–240
Timeouts
Sleep Mode
Disabled
1–120
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
Timeouts
Prolong Screen Timeout
On
Off
To
Set the amount of time before the printer enters a lower power
state.
Note: 15 minutes is the factory default setting.
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
•
20 minutes is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
• Lower settings conserve more energy, but may require
longer warm‑up times.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Print a job with the display turned off.
Note: Display on when printing is the factory default setting.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Notes:
•
Do Not Hibernate is the factory default setting.
•
The fax function is available only in select printer models.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 seconds is the factory default setting.
Continue a specified job without returning to the home screen
when the screen timeout timer expires.
Note: Off is the factory default setting.
168