Mytee 8070 Lite Instructions Manual page 7

8070 MYTEE LITE™ OPERATION
VACUUM SWITCH
Turn on vacuum motor and begin cleaning. For best
results make two dry passes for every wet pass.
EMPTY SOLUTION TANK
To empty any remaining water in the solution tank, remove
cap which is located at the front of the solution tank.
RECOVERY TANK DRAIN
Located at the rear of the Mytee Lite™ is a bucket high
drain valve. Before extracting, screw on the included
A110 drain hose. When you're finished extracting, un-
screw the T-handle cap on the hose to drain the tank.
VACUUM STACK FILTER
The Mytee Lite's™ internal filter must be cleaned regu-
larly and is located in the recovery tank. Twist the filter
to remove then clean and replace. If the filter is torn or
damaged, replace with a new one.
7