Mytee 8070 Lite Instructions Manual page 6

8070 MYTEE LITE™ OPERATION
FILL SOLUTION TANK
To fill the solution tank, use a bucket to pour water into
the tank's opening located at the front of the unit. You can
also use the easy faucet fill also located at the front of the
unit. For best results, fill with warm water (140° F).
PUMP SWITCH
After the machine has been plugged into a 20 amp
grounded outlet, turn on pump. Pull trigger on cleaning
tool until tool releases a steady flow.
ATTACH HOSES
Attach female end of a solution hose to a wand or tool
and the male end to the Mytee Lite's™ QD. Then connect
a vacuum hose to a wand and the male Cuff-Lynx™
hose port.
HEATER SWITCH
Release tool trigger. Turn on heater. Wait 5 – 7 minutes for
unit to pre-heat. Once heated, pull trigger on tool until hot
water begins flowing.
6