Mytee 8070 Lite Instructions Manual page 4

GENERAL INFORMATION
FAQs
Q: What comes standard with the 8070?
A: The 8070 comes with 15' 1-1/4" Hose-n-Hose™ Vacuum/ Internal Solution Hose
Combo (8501), a 4" Stainless Steel Upholstery Tool (8400), Cuff-Lynx™ H122, and a
drain hose (A110).
Q: Does Mytee recommend a tool for the machine?
A: A variety of tools can be used with the unit, including our 8390 wand, 8700 crevice
tool, 8400 upholstery tool, and 8400DX Mytee Dry™ upholstery tool.
Q: Where do I plug the machine in?
A: The 8070 requires a 20A grounded circuit. Please note: GFI outlets may trip
before the breaker setting.
Q: What is the proper pre heat cycle for the 8070?
A: Turn pump switch to the on position and prime pump through the solution hose
and the tool. Then turn the heater switch to the on position. Let the machine sit idle
for 5-7 minutes. Spray tool until you feel the hot water from the jet.
Q: Are the pumps re-buildable for the 8070?
A: Yes, both the seals and the pistons have repair kits available.
Please see the pump manual that shipped with your machine for the
maintenance schedule.
Q: Is there anything I can do to increase the expected life of my machine?
A: Running the vacuum motors with the tank empty and lid off will allow excess
moisture in the vacs to dry off. You should also run a System Maintainer through
the system to keep the hoses, pump, and heater clean and free of debris.
4