Electrical Instruction - Philips 221TE2LB/00 Service Manual

Electrical characteristics
1. VIDEO SIGNAL REQUIREMENTS
1.1 CVBS input -1000mVpp (including 300 mV sync level), terminated with input impedance of 75 .
1.2 S-Video input - Y: 1000mVpp, C: 300mVpp, terminated with input impedance of 75 .
1.3 Component video input - Y: 1000mVpp, PbPr: ±350mVpp, terminated with input impedance of 75 . 480i/p,
576i/p, 720p, 1080i, 1080p signal handling capability.
1.4 HD ready -
Display engine:The minimum native resolution of the display (e.g. LCD, PDP) or display engine (e.g. DLP) is
720 physical lines in wide aspect ratio.
Video Interfaces:
The display device accepts HD input via:
Analog YPbPr. "HD ready" displays support analog YPbPr as a HD input format to allow full compatibility with
today's HD video sources in the market. Support of the YPbPr signal should be through common industry
standard connectors directly on the HD ready display or through an adaptor easily accessible to the consumer;
and:
DVI or HDMI HD capable inputs accept the following HD video formats:
1280x720 @ 50 and 60Hz progressive scan ("720p")
1920x1080 @ 50 and 60Hz interlaced ("1080i")
The DVI or HDMI input supports copy protection (HDCP).
1.5 SCART - Full SCART, includes CVBS in/out, RGB/Sync, audio L/R in/out. Pin 8, the function-switching pin,
carries a signal from the source that indicates the type of video present,
0V means no signal, or internal bypass
+6V means a widescreen (16:9) signal
+12V means a normal (4:3) signal
1.6 HDMI input - Compliance with HDMI Specification 1.3a. 480i/p, 576i/p, 720p, 1080i/p signal handling capability.
TMDS channel:
Carries audio, video and auxiliary data.
Signaling method: According to HDMI Ver.1.3a specification. (Type A HDMI).
Video pixel rate: 25 MHz to 165 MHz (Type A)
Pixel encodings: RGB 4:4:4, YCbCr 4:2:2, YCbCr 4:4:4.
Audio sample rates: 32 kHz, 44.1 kHz, 48 kHz, Audio channels: up to 2
DDC channel:
Allows source to interrogate capabilities of sink.
I²C signaling with 100 kHz clock.
E-EDID data structure according to EIA/CEA-861B and VESA Enhanced EDID.
Content protection:
According to High-Definition Content Protection (HDCP) Specification 1.10.
1.7 Common Interface - Complies with version 1: EN50221 ETSI TS 101 699, V1.1.1 (1999-11) and [R206-001F]
(DTV only)
1.8 No signal input - While no signal at external inputs, screen goes black (blue) before entering standby mode.
2. Timing requirement
Electrical Instructions
HD ready logo required. (Must Have)
221TE2L LCD 25