Electrical Instruction - Philips 220S W9FS /00 Service Manual

16 220SW9 LCD
1.Electrical Characteristics
1.1 Interface signals
1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level , input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
1.2 Interface
D-Sub Cable
Length : 1.8 M +/- 50 mm
Fix with monitor when packing, with transplant pin protective cover.
Connector type : D-Sub male with DDC2B pin assignments.
1.3 Timing requirement
1.3.1 Mode storing capacity
Factory preset modes : D-sub :18 , DVI : 17
Preset modes : 49
User modes : 10
1.3.2 Factory preset modes ( D-sub18 modes)
Electrical Instructions
Blue connector thumb-operated jack screws