Philips 221TE2LB/00 Service Manual page 102

102 221TE2L LCD
7.10 Paint Used
RoHS requirements.
WEEE requirements.
If new painting type need to implement, refer to UN-D 1235
7.11 Plastic Mold Tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.), Reference to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.
Design of a separated room on front cabinet by using wall, rib, sponge...etc. for ensuing both
speaker enclosure (RH/LH) is segregated
7.12 Plastics Flammability
All Plastics to be Flame Retardant UL 94- HB or Better.
All major plastic parts (bezel, back cover, base) is better to be molded from same resin.
7.13 Texture/Glossing of Housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to UAN-D249 and UN-D 600.
Glossy surface > = 80 gloss units
7.14 Base Tilt / Swivel Range
Tilt angle :
Swivel angle :
Base detach -
Tip over -
© MMD 2010
General Product Specification
-5 +2/-0 (forward)
+20 +0°/-2°(backward)
nil
Should be directly disassembled from main body, so as for easy
install the set to wall mount.
10° minimum in worst case, base dimension designed so that ID
and tip over requirements can be met.
Page 39 of 45