Marshall Electronics CV610-U3 User Manual page 13

RS232 Connection
1. Set Bottom Dip Switch SW1-B6 to OFF. (See page 16).
2. Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
(See page 16).
3. Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4. Camera ID address setting (see page 16).
5. The controller must be VISCA compatible.
Camera does not support Daisy Chain in RS232 control mode.
6.
You can make RS232 connection cable if you have the following applications:
7.
Use RS-422(VISCA) / RS485 (PELCO P/D)
You can use RS-422/485 port connect to optional controllers, such as joystick control keyboard, control PC station,
to operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform the Preset
operation using the control buttons.
An application software that supports this unit is needed if you use PC station.
RS422/482 Connection
13