Camera Control Methods And System Configurations - Marshall Electronics CV610-U3 User Manual

Camera Control Methods and System Configurations

This unit has multiple ways of controlling the USB3.0 camera and various system configuration capabilities using
optional products. This section describes ways of controlling and typical system examples with the required
components and usage of each system.
1. Use the Infrared Remote Controller
2. Use Third party video conference software (UVC1.5 compliant).
3. Use camera built-in virtual COM port.
4. Use RS-232 (VISCA), via Extension Module (optional).
5. Use RS-422(VISCA)/485 (PELCO P/D) via Extension Module (optional).
Use the Infrared Remote Controller
To operate the camera from a short distance.
System Configuration A
For IR remote control details, refer to Operation Using the Infrared Remote Controller, see page 22.
Use Third party video conference software (UVC1.5 compliant).
The camera can be controlled by any third party UVC1.5 compatible video software. Use USB3.0 cable to connect
the camera to the PC/device equipped with UVC1.5 compatible software, the camera will be recognized
automatically. Follow the instruction of the video software you are using. You can control the camera via PC, Pad,
Smartphone.
1. Install video client software on the computer that you want to use the
camera on.
2. Use the USB3.0 cable to connect the camera to the computer.
Connect the power adapter to the camera and the power outlet.
3. Power on the camera, wait for a while, the camera will be recognized
and installed automatically by the computer. USB3.0 driver is not
required for the camera.
4. Open the video client software (Here, we use ZOOM ROOM for
example), on left bottom under "Stop Video" setting, select video
device from Camera list "USB3.0 Video Camera".
5. On left bottom under "Mute" Audio setting, select video device from
Microphone list "Digital Audio Interface (2-USB3.0 Video Camera)".
6. Interface of the setting page and terminology of the setting items may
vary according to the video client software you are using.
7. You can have the video displayed after you made above selection.
Right Click mouse to pull out action selection, to Request Camera
Control from the meeting group.
8. After you get approve from the meeting group, the
control intereface will pop up. You can control the
camera.
9. For camera control detail, please refer to video software
user guide.
11