Seq Recording And Chord Mode; Seq Playback And Chord Mode; Chords And The Arpeggiator; Keyboard Midi Channel - Arturia Keystep User Manual

4.1.1.1

Seq Recording and Chord mode

Chords from Chord mode will be recorded as independent notes in the sequencer. So if
you have a 6-note chord it will occupy 6 of the 8 note maximum that is allowed in a
sequence step.
4.1.1.2

Seq playback and Chord mode

The keyboard is in one of two modes during sequence playback: Transpose or Kbd Play.
When the keyboard is set to Transpose mode, the keys are used to transpose the
sequence. Chord mode is disabled in this case, as it would be difficult to be certain which
note in the chord was the transposition center.
When the keyboard is set to Kbd Play mode then Chord mode can be used to play chords
on the target device.
These modes are discussed further in section 4.3.3.
4.1.2

Chords and the arpeggiator

The arpeggiator can be used in conjunction with Chord mode to play arpeggiated chords.
The process is simple:
 Make sure the Seq / Arp toggle switch in the Arp position
 Start the arpeggiator with the Play/Pause button
 Enter Chord mode by holding Shift and pressing the Hold button
 Play two or more notes so you can hear the chord being transposed by the
arpeggiator.
That's all there is to it. And it doesn't matter whether you start the arpeggiator first and
then activate Chord mode or do it the other way around. The results will be the same.

4.2 Keyboard MIDI channel

There are numbers silkscreened above the keys under the heading "Keyboard MIDI CH".
These represent the 16 MIDI channels to which the keyboard can be assigned. To
change the MIDI channel setting, hold the Shift button and press the key that
corresponds to the desired MIDI channel.
When the MIDI channel is changed the Kbd Play MIDI channel will change to
match it. To select an independent channel for Kbd Play mode, see section 4.3.3.2.
22 ARTURIA – KeyStep – USER'S MANUAL