Rear Suspension; Adjust Rear Shock Absorber - Victory Motorcycles V92C Owner's Manual

Maintenance

Rear Suspension

Adjust Rear Shock Absorber

The distance measured while the motorcycle is
Notice
elevated will not change, and needs only be measured once. After
the measurement and the locations from where the measurement
is taken is recorded (steps 1- -4), you will only need to perform
steps 5- -8 in the to correctly adjust the rear shock absorber.
Have an assistant help you complete the following procedure.
1. Elevate the rear of the motorcycle until the rear wheel
is about 1 inch (2.5 cm) off of the ground. Use an
appropriate motorcycle lift or a block of wood or steel
placed securely under the frame.
2. Measure the distance from the center of the rear axle to
the bottom of the rear fender directly above the axle.
On some models it may be easier to measure from the
top of the drive belt guard to a convenient spot on the
rear fender (along the pinstriping for example). Both
locations must be directly above the rear axle.
3. Record the measurement and the locations from where
the measurement is taken in the space provided.
4. Remove the motorcycle lift apparatus and return the
motorcycle to the ground.
82
2
1. Center of Rear Axle
2. Bottom of Rear Fender
Measurement (step 2)
Upper Location (step 2)
Lower Location (step 2)
1