5 - 10 MC7090CN User Guide
Cables
Troubleshooting the Cables
Table 5-7
Symptom
EDA battery is
not charging.
During data
communication
, no data
transmits, or
transmitted
data was
incomplete.
Magnetic Stripe Reader
Troubleshooting the Magnetic Stripe Reader
Table 5-8
Symptom
MSR cannot
read card.
Possible Cause
EDA was
Connect the power cable correctly. Confirm main battery is
disconnected from AC
charging under Start - Settings - System - Power. The standard
power too soon.
capacity battery (1900 mAh) fully charges in less than four hours.
The extended capacity battery (3800 mAh) fully charges in less
than eight hours.
Battery is faulty.
Verify that other batteries charge properly. If so, replace the faulty
battery.
The EDA is not fully
Detach and re-attach the power cable to the EDA, ensuring it is
attached to power.
firmly connected.
Cable was
Re-attach the cable and retransmit.
disconnected from
EDA during
communications.
Incorrect cable
See the system administrator.
configuration.
Communication
Perform setup as described in the MC7090CN Integrator Guide.
software is not
installed or configured
properly.
Possible Cause
MSR removed from
Reattach MSR to EDA and reswipe the card.
EDA during card
swipe.
Faulty magnetic stripe
See the system administrator.
on card.
MSR application is not
Ensure the MSR application is installed on the EDA.
installed or configured
Ensure the MSR application is configured correctly.
properly.
Action
Action