Motorola MC7090CN User Manual page 104

5 - 12 MC7090CN User Guide
Troubleshooting the Trigger Handle
Table 5-9
Problem
EDA battery does not
charge when Trigger
Handle is placed in a
cradle.
Cannot print to printer. Printer cable not
EDA does not wake
from suspend mode
when trigger is
pressed.
Cause
Trigger Handle is not
properly seated in the
cradle.
Power is not available to
the cradle.
connected properly.
The trigger only wakes
the EDA from the
suspend mode if a
scanning application is
active.
Solution
Remove the Trigger Handle from the cradle and
reinsert.
Ensure that power connections to the cradle are
connected properly.
Ensure cable is connected properly to the printer and
Trigger Handle.
Press a key on the EDA to wake from the suspend
mode.