Installation And Lubrication; Parts And Maintenance - Ingersoll-Rand 2135TiMAX Product Information

EN
Impacting Sound Level
Models
† Pressure
2135TiMAX
2135TiMAX-AP
2135Ti-2MAX
2135Ti-2MAX-AP
2135QTiMAX
2135QTiMAX-AP
2135QTi-2MAX
2135QTi-2MAX-AP
2135QPTiMAX
2135QPTiMAX-AP
2135PTiMAX
2135PTiMAX-AP
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 47132782 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
dB(A)
(ISO15744)
‡ Power (L
(L )
w
p
99.8 110.8
99.8 110.8
94.2 105.2
94.2 105.2
94.2 105.2
99.8 110.8
Free Speed Sound Level dB(A)
(ISO15744)
) † Pressure (L ) ‡ Power (L
p
109.2
109.2
86.0
86.0
86.0
109.2
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
Vibration (m/s²)
(ISO28927)
) Level *K
w
120.2 13.3 4.6
120.2 9.7 1.8
97.0 13.3 4.6
97.0 9.7 1.8
97.0 13.3 4.6
120.2 13.3 4.6
45534062_ed4