Installation And Lubrication; Parts And Maintenance - Ingersoll-Rand 2131 Series Product Information

Air impact wrench

Hide thumbs Also See for 2131 Series:

Table of Contents

Available languages

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain

condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a

properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose

coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-

nects. See drawing 47132782 and table on page 2. Maintenance frequency is shown in a circular

arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:

1. Air Filter

2. Regulator

3. Lubricator

4. Emergency shut-off valve

5. Hose diameter

6. Thread size

When the life of the tool has expired, it is recommended that the tool be disassembled, de-

greased and parts be separated by material so that they can be recycled.

Original instructions are in English. Other languages are a translation of the original instructions.

Tool repair and maintenance should only be carried out by an authorized Service Center.

Refer all communications to the nearest Ingersoll Rand Office or Distributor.

EN-2

Coupling

Safety Air Fuse

Oil

10. Grease - during assembly

11. Grease - through fitting

04584686_ed7

Table of Contents